Plant material flow

AGV Material Transport

Coordinate finished-roll or parent-roll movement between defined stations, routes and production interfaces.

  • Defined pickup and drop-off stations
  • Route and traffic review
  • Production-line handshakes
Concept visualization of an AGV carrying a finished film roll through a converting plant
Concept visualization. The final vehicle, load carrier, navigation system, traffic rules and station interfaces are engineered and supplier-confirmed for the actual facility.
01Inputs firstStart from the real roll, tooling, route or cell
02Interfaces mappedMechanical, control and operator handoffs stay visible
03Risk reviewedMaterial, load, access and recovery conditions are documented
04Scope confirmedFinal configuration remains supplier-confirmed
Workflow objective

Connect production stations with a load unit the vehicle can handle safely

An AGV is only one part of the transport system. Roll support, pickup geometry, route clearance, floor condition, traffic interaction and station controls determine whether the workflow is practical.

SlitForge maps the handling route and coordinates the review between the converting-equipment supplier and the material-transport provider. Final responsibility at every handoff is stated in the proposal.

Starting point
A defined roll cradle, pallet, shaft cart or another stable load unit
Transport path
Dock, identify, travel under traffic rules, then hand off at a known station
Confirmation basis
Load, route, floor, cycle, navigation, controls and plant safety review
Typical sequence

Four interfaces turn vehicle movement into a production workflow

Each station needs a repeatable mechanical position and a clear control handshake before autonomous movement can be accepted.

  1. Receive

    The load is stabilized at a defined pickup height, orientation and docking position.

  2. Identify

    The system confirms the load, destination and transport permission before departure.

  3. Travel

    The vehicle follows the approved route with obstacle detection and plant traffic rules.

  4. Handoff

    The destination station confirms alignment and readiness before the load is released.

Configurable scope

Vehicle and station scope are reviewed as one system

  • Low-profile, forked or custom load-carrier vehicle
  • Roll cradle, pallet or shaft-cart interface
  • Docking and position-confirmation hardware
  • Navigation, traffic management and charging strategy
  • Station PLC handshake and job dispatch
  • Optional load identification, weighing or traceability
Before quotation

Responsibility and acceptance points stay visible

Load interface

Support geometry, retention and allowable contact points are confirmed before vehicle selection.

Facility route

Floor, clearance, fire routes, pedestrian zones and local safety requirements remain visible.

Control ownership

Dispatch, station handshake, recovery and manual override responsibilities are documented.

Start with the route

Share the load unit, stations and plant layout

We will map the handoffs and coordinate a supplier-confirmed AGV integration review.

Request a Quote
Request a QuoteWhatsApp